Copy Link
Add to Bookmark
Report
Xenon Foundation 03
__
\ / |_
/ \ e n o n | o u n d a t i o n
presents:
\ /
*------ the \ /
/ \ files ------*
/ \
Fall/1993 Issue: 3
INTRODUCTION TO BASIC DIGITAL TECHNOLOGY
Written by: Erik Turbo
File: 3 of 6
3. Channel Banks
3.1 Introduction
In this next section you will learn about a typical digital facility. Most
digital facilities contain:
> Channel Banks
> A Transmission System
You will learn about the channel banks and a typical transmission system
which includes:
> Loop Plant
- Loop Cables
- Impairments
- Digital Loop Carrier (DLC)
- SCL 96--Modem 3
3.2 Digital Channel Banks
> The function of the digital facility is to provide 24 Voice Frequency (VF)
channels from one point to another over a PCM transmission system. The
most basic type of digital facility consists of two elements:
1. Channel Banks (or terminals)
2. A Transmission System
> The channel banks provide the A/D interface between 24 VF circuits and a
digital Pulse Code Modulation (PCM) transmission system. The digital
transmission signal between two channel banks.
3.3 Loop Plant
The loop plant is the connect between the telephone customer and the serving
Central Office. Most loops are quite short, the median length is about
1.7 miles.
1. Loop Cables
The loop plant gernerally consists of metallic cable pairs. Typical
cable gauges are the 19, 22, 24, or 26 gauge. The higher the gauge
number, the smaller the wire diameter and the more resistance per foot.
CABLE GAUGE OHMS/KFT
-------------------------------------------------------
26 83.2
24 51.9
22 32.8
19 16.3
2. Impairments
As the distance from the Central Office increases, so does transmission
loss. Switching systems and telephone equipment are designed to oper-
ate at specified limits, therefore, the loop plant is generally limited
without treatment from 1,300 to 1,500 ohms. In addition the resistance,
another factor that impacts transmission is loop capacitance.
3. Digital Loop Carrier (DLC)
The loop capacitance results in greater loss at the higher frequencies.
To care for this, loop cable over 18 Kft are equipped with load coils.
New loop cable configurations, longer than 24 Kft, generally used
Digital Loop Carrer (DLC) such as SLC 96.
3.4 Digital Loop Carrier (DLC)
Digital Loop Carrier (DLC) systems are being installed in significant
numbers, about 50,000 DS1 lines per year, to provide new services and
reduce cost. The systems in use include AT&T SLC 96 system, Norther
TELECOM's DMS-1 Urban, and systems from other vendors.
The SLC 96 system is a digital subscriber carrier system which provides
up to 96 subscriber lines. It provides residential, coin, and special
services. SLC 96 operates in three modes with Mode 3 used for special
service including Digital Data Services (DDS) dataport.
This SLC 96 layout is similar to Mode 1 and Mode 2 having a Central
Office (CO) and Remote Terminal (RT). The major difference is that the
channels are reduced from 24 to 12 for each bank. D4 Channel units can
be used in the SLC 96 Mode 3 arrangement
The Mode 3 arrangement has two T1 (DS1) lines plus one T1 for protection
in case of a line problem on either of the service lines.
------------------------------------------------------------------------------
EOF ---------------- Xenon Foundation Productions 1993 -------------------EOF
------------------------------------------------------------------------------
