X-B.I.T Wire Installation
/*Step 1*/
Remove top cover from your XBox.
/*Step 2*/
Remove the DVD-Drive and the HDD. You do not need to remove the XBox mainboard.
You need to get acces to areas "A", "B" and "C".
Step 3
Grasp the seal with your thumb and your forefinger and break it away.
Step 4
Specify the version of XBox and solder the wires to the points shown above. We recommend to solder wire "4" (xD0 bridge) at last. Please insulate the pogopins and the pinheader with non-conductive adhesive tape to avoid any shorts.
ALTERNATIVE: STEP 5
Attention:
Step 7 is an alternative installation for users that want to activate/deactivate the X-B.I.T Stealth-Mode by pressing the XBox power button as described in the Link above. This step is not essential.
Click here if you want to use the XBox power button to activate/deactivate the X-B.I.T Stealth-Mode.
Attention: Soldering iron required!!!
If you do not wish to solder to your XBox continue with step 8. The X-B.I.T Stealth-Mode can also be activated/deactivated with the dip-switch on the X-B.I.T external board.
Step 6
Plug in the wire connector carefully to 11 Pin connector on the X-B.I.T internal board as shown on the image above. Ensure once again that all wires are properly soldered to the according points. The pogopins and the pinheader need to be insulated.
Step 7
Connect the wires to the internal board as shown above and ensure that you don't mix up the wires. Connect the yellow wires to the socket marked with "Y"and connect the black wires to the socket marked with "B".
Step 8
Route the wires carefully to the casing of the XBox and put them carefully through the cut-outs of the casing as shown above. The internal installation is now completed.
Step 9
Connect the wires to the external board as shown above and ensure that you don't mix up the wires. Connect the yellow wires to the socket marked with "Y"and connect the black wires to the socket marked with "B". Remove the tape from the dip-switch.
Step 10
Route the wires carefully to the area of the XBox as shown above. Use adhesive-tape to fix the X-B.I.T external board on the back of the XBox. The physical installation is now completed.
